Ordinary Wire Straightening Machine Installation Counting Function Straightening

1, must be familiar with the operating instructions before starting, and according to the provisions of the increase in lubricants, check the fasteners are tightened, the direction of rotation of the shoe is in line with the provisions of the direction, find the problem, please promptly deal with. 2, check the thread on the knife on the nut is loose, cross-cutting knife and vertical cut the gap between the knife to adjust the smaller the better, but not too tight, generally can slide up and down is appropriate, the punch and vertical cut the knife Up and down the gap is generally 2-3mm, punch and vertical cut the knife blade pressure is generally 4-5mm. 3, hand touch straight after the silk feel a small bend, which shows the straightening mode angle, then adjust the use of smaller, if there is a big bend, to adjust the angle of the mold increase, if not straight, It is necessary to check the high-speed rotor blades, and cross-cutting knife hole, is not the horizontal position, these three must be a line, the level can not deviate from the left. 4. If there is broken wire, it is necessary to check whether the compression spring on the shoe is not tight pressure, or the groove on the shoe wheel wear serious, adjust the groove after the groove or not, it is necessary to change the fan On the groove. 5, if there is broken head on the burr, it may be too wide cut off the knife blade gap is too large, it is necessary to adjust the gap between the vertical and horizontal knife, if not enough, in the inspection of the vertical knife is serious wear and tear, if the wear and tear, put the vertical knife And cross-wire cutter to remove the cross-filament knife in the alloy grinding wheel grinding, vertical thread cutter in the general grinding wheel grinding until the sharp so far. 6, if there is a continuous cut off, it may be tension spring to send, adjust the tightening of the tension spring, it may be the shaft of the reed spring to send, do not move the runway need to adjust the shoe shaft compression spring.