Straight machine straight wire machine installation and commissioning instructio

Straightening machine straight wire machine installation and commissioning
1, the first body on the flat basis, the installation of the body and the truncated pole to put the level (cut off the rod and the body connected to the right side of a block so that the cutting rod to maintain 4-5 mm to form), then the motor switch connected Power supply, and then move the switch handle, if the direction of rotation of the shaft is not changed to change the direction of the switch.
2, all the rotating parts to add a good oil, butter.
3, before the boot to put down the protective cover, check the motor connector is leakage. In the straightening machine body to get a good ground.
4, idle 2-3 minutes, and then penetrate the wire into the high-speed rotor (when the machine is in a static state), in the use of a forklift to suppress the wire, hand pulley will be sent to the cutter blade mouth.
5, adjust the high-speed rotor within the adjustment mode angle size, to achieve the effect of straight wire can work properly.
Straightening machine use and maintenance
1, must be familiar with the operating instructions before starting, and according to the provisions of the increase in lubricants, check the fasteners are tightened, the direction of rotation of the shoe is in line with the provisions of the direction, find the problem, please promptly deal with.
2, check the thread on the knife on the nut is loose, cross-cutting knife and vertical cut the gap between the knife to adjust the smaller the better, but not too tight, generally can slide up and down is appropriate, the punch and vertical cut the knife Up and down the gap is generally 2-3mm, punch and vertical cut the knife blade pressure is generally 4-5mm.
3, hand touch straight after the wire feel a small bend, which shows the straightening mode angle, then adjust the angle becomes smaller, if there is a big bend, to adjust the angle of the mold increase, if not straight To check the high-speed rotor shaft, and cross-cutting knife hole, is not the horizontal position, these three points must be a line, the level can not deviate.
4. If there is broken wire, it is necessary to check whether the compression spring on the shoe is not tight pressure, or the groove on the shoe wheel wear serious, adjust the groove after the groove or not, it is necessary to change the fan On the groove.
5, if there is broken head on the burr, it may be too wide cut off the knife blade gap is too large, it is necessary to adjust the gap between the vertical and horizontal knife, if not enough, in the inspection of the vertical knife is serious wear and tear, if the wear and tear, put the vertical knife And cross-wire cutter to remove the cross-filament knife in the alloy grinding wheel grinding, vertical thread cutter in the general grinding wheel grinding until the sharp so far.
6, if there is a continuous cut off, it may be the tension spring to send, adjust the tightening of the tension spring, it may be the shoe wheel of the pressure spring, push the runway need to adjust the shoe shaft compression spring. In short, to see the actual Situation may be.