Sieve plate production process is very important to debug the mold

There are many kinds of materials made of sieve plate, such as low carbon steel plate, stainless steel plate, aluminum plate, aluminum-magnesium alloy plate, etc. The laser stamping, its mesh surface is smooth, smooth, durable, and resistant to bending, anti- Rust, the use is also very wide in the production process of the sieve plate, the mold is very important to debug the guide bending mold by the guide device to determine the relative position of the upper and lower mold, no guide device sieve plate mold in the relative position on the press , The general adjustment of the length of the press connecting rod. Adjust the time, should make the mold slide to the lower pole, so that both the compaction of the workpiece, nor the occurrence of rigid or bite the phenomenon of sieve plate adjustment test pressure, Placed in the mold work position adjustment.As the sieve section slightly conical, if the sieve plate is improperly installed, so that the large aperture up, small aperture down, prone to sieve card material, therefore, the installation must pay attention to the direction of the aperture , Should make the hole up, big hole down.