Straight wire machine operating principle

Straight wire machine operating principle: the motor through the belt drive speed, so that straight high-speed rotation, through the straightening of the bar was straightened, and straightened by the steel mold surface to remove rust; by the motor through another pair of deceleration belt drive And gear reducer, on the one hand drive two delivery roller, traction steel forward movement, on the other hand drive crank wheel, so that the hammer up and down movement. When the steel bar to adjust the length until the predetermined length, the hammer hammer on the knife, the steel cut off, cut off the steel into the receiving frame, the role of the spring, knife Taiwan back to the original position to complete a cycle. 1. Performance structure: Straightening mechanism - by the straightening roller, straightening pressure block, and both ends of the bearing structure to complete the straightening of the wire work. Its power is installed in the lower part of the motor frame, driven by the V-belt to adjust the high-speed rotation axis. Feed mechanism - roller part of the wheel by the two synchronous operation of the composition, through the V-belt chain drive, driven by a pair of gears, the coaxial pair of pressure wheel along with synchronous operation. Work, the metal wire through the groove of the outer circle of the roller under the action of friction in the forward run, adjust the pressure roller spring can change the wire feed rate. Its maximum value is equal to the outer circle speed roller. Work, should be based on the diameter and rigidity of processing wire to adjust the pressure, in order to obtain the best straightening effect and production efficiency.
Straight wire machine, nickname straightening machine, straightening cutter, mainly for all kinds of metal wire for automatic straightening cut, including flat wire straight cut off, building tie wire straight cut off, galvanized wire straight cut off, stainless steel wire Straighten and cut off the wire Straighten and cut for straightening and cutting off the diameter of 14 mm below the cut length can be customized according to customer requirements. Adjustable straight cut off the stainless steel wire, aluminum wire, cold drawn wire, plastic bag steel wire, incision Qi, the error is small, good performance.